Some people will ask: do you know the removal glue in the maintenance of led line lamp? In fact, any led lamps and lanterns need to be repaired, led line lamp is no exception, and in the maintenance process, will be used to remove glue. So, what are the discharges, what are the situations that need to be used to remove the glue?

1. After filling the glue, it should be disassembled and refilled due to improper handling or position dislocation.

2. The light source components need to be disassembled and analyzed when the led underground lamp, led underwater lamp, led wall lamp, led line lamp, etc.

3. It may be necessary to remove the original packaging of soft glue or stone hard glue when the light sources such as anti-lumen and COB are analyzed.

4. Waterproof power source and light source module are discarded, and then recover the valuable parts.

5. Analysis of the necessary decontamination when testing, testing, product certification, project acceptance or production process confirmation.

6. The method of the led line lamp and the cleaning of the wall lamp are percussion vibration method, stripping method, moment method, heating method, solvent method, soaking method, alkali solution and so on. For outdoor lighting lamps and lanterns products because of special installation position, the glue will generally choose transparent, white or black soft rubber, and soft glue used in outdoor environment not easy hardening crack. This kind of led line light gel can be removed by gently drawing with a knife or tweezers.

1. The led line lamp is divided into high voltage (220V) and low pressure (12V). Where is the difference?

High pressure and low pressure has its own advantages and disadvantages, high pressure easy to use, do not need power supply, does not occupy a space, and cost savings. But bring due to high pressure lights is 220 v ac by plug into 220 v dc, again through a meter lamp of distribution power supply, so the current distribution is not average, the power is not constant, so the life is shorter than the low pressure.

Connect the butt insert, remove the pin, insert the wire from the lamp wire, and make sure that the pin is in full contact with the wire wire, which can conduct the conductive action.

2. What are the differences between the led line lamp 3528 and the 5050 model?

Refers to the size of the chip 3528 and 5050, 3528 is 35 * 28505 0 is 50 * 50, so 5050 chip to more than 3528 big many, therefore, is also much more brightness, generally about 5050 brightness is three times as many as 3528, 5050, highlighting similar to conventional T5 lamp brightness, hotel, shopping mall, etc. 3528 can be used in general household living room, bedroom and so on place.

The led line light is cut, and there is a blank space between each meter. It can be cut in this vertical. Do not cut the light between other beads.

3. Can the led line lamp be waterproof? Can it be soaked in water?

The answer is yes, can waterproof, we produce waterproof led line light waterproof grade reaches IP65, fore and aft two head need glass glue sealing, waterproof and moistureproof effect, because of high voltage led lamp line, for security reasons, please don't put the led line light soaking in the water.

Power line connection, remove the power cord and plug on the pin of the power cord is inserted. If plugged in rear light is not bright, can start from step 2, on the other side of the pin inserted into the lamp with (if your lamp install where is wet, please use the interface with glass glue sealing).